Scallop Stitching; Smocking - Brother CE1125PRW Operation Manual

4
Select stitch or .
5
Set the stitch width to 7.0 mm (1/4 inch).
(Refer to page 26.)
6
Sew with the center of the presser foot
aligned along the center of the two pieces of
fabric.
7
After sewing is finished, remove the paper.

Scallop stitching

The wave-shaped repeating pattern that looks
like shells is called "scalloping". It is used on the
collars of blouses and to decorate the edges of
handkerchiefs.
1
Attach monogramming foot "N".
2
Select stitch .
3
Stitch along the edge of the fabric, making
sure not to sew directly on the edge of the
fabric.
• For better results, apply spray starch onto the
fabric and press with a hot iron before it is
sewn.
4
Trim along the stitches.
• Be careful not to cut the stitches.

Smocking

The decorative stitch created by stitching or
embroidering over gathers is called "smocking". It is
used to decorate the front of blouses or cuffs. The
smocking stitch adds texture and elasticity to fabric.
1
Attach zigzag foot "J".
2
Select the straight stitch, and then adjust
the stitch length to 4.0 mm (3/16 inch) and
loosen the thread tension.
• For details, refer to "Selecting a stitch" (page
25) and "Thread tension" (page 27).
3
Sew parallel stitching at intervals of 10 mm
(3/8 inch).
1
• Do not sew reverse/reinforcement stitches or
cut the thread.
4
Pull the bobbin threads to create gathers.
Smooth the gathers by ironing them.
5
Select stitch or .
6
Stitch between the straight stitches.
7
Pull out the threads for the straight stitches.
UTILITY STITCHES
3
1 10 mm (3/8 inch)
45