Table of Contents
Advertisement
Windows NT 4.0 Configuration
B
Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Confirm with the network administrator that the settings are correct.
C
Click the [Services] tab, and confirm that "Microsoft TCP/IP Printing" is in-
stalled.
If "Microsoft TCP/IP Printing" is not installed, click [Add] on the [Services]
tab, and install it. For more information about installing and configuring net-
work services, see Windows NT Help.
3
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information about how to make the above settings, see the Setup
Guide that comes with this printer.
Configuring a Windows NT computer
Install the NetBEUI protocol on the Windows NT computer, and change the
LAN adapter number (Lana Number).
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "Net-
BEUI Protocol" is listed in the [Network Protocols] box on the [Protocols] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] on the [Protocols] tab,
and install it. For more information about installing the NetBEUI protocol,
see Windows NT Help.
B
Change the Lana Number. Click the [Services] tab, click "NetBIOS Inter-
face" in the [Network Services] box , and click [Properties].
C
Click the Lana Number corresponding the Nbf protocol of the [Network
Route] headline, and click [Edit].
34
Advertisement
Table of Contents
