Table of Contents
Advertisement
B
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Confirm with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows 95/98/Me to use the NetBEUI protocol.
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information about how to make the above settings, see the Setup
Guide that comes with this printer.
Configuring a Windows 95/98/Me computer
Install the NetBEUI protocol on the Windows 95/98/Me computer and set it as
the default protocol.
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "Net-
BEUI" is listed in the [The following network components are installed:] box on
the [Configuration] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] on the [Configuration] tab
and install it. For more information about installing the NetBEUI protocol,
see Windows 95/98/Me Help.
❒ If "NetBEUI ->Dial-Up Adaptor" is listed in the [The following network com-
ponents are installed:] box, select it and click [Remove] to remove the binding.
B
Set the NetBEUI protocol as the default protocol. Click the [Configuration]
tab, select "NetBEUI" in the [The following network components are installed:]
box, and click [Properties].
C
Click the [Advanced] tab, select [Set this protocol to be the default protocol], and
click [OK].
D
Click [OK] to close the [Network] dialog box.
E
When the message to restart appears, click [Yes].
Configuring Protocols
1
3
Advertisement
Table of Contents
