Paper Tray Unit - Gestetner F530 Install Manual

Installing the Optional

Paper Tray Unit

If you install the Optional Paper Tray Unit later, read the
following WARNING, CA UTION and Impor tant, and then
perform to .
R WARNING:
• Connect the power cord directly into a wall outlet and
never use an extension cord.
R CAUTION:
• Unplug the power cord from the wall outlet before you
move the machine.
While moving the machine, you should take care that
the power cord will not be damaged under the
machine.Unplug the power cord from the wall outlet
5 before you move the machine. While moving the ma-
chine, you should take care that the power cord will
not be damaged under the machine.
• When you disconnect the power plug from the wall
outlet, always pull the plug (not the cable).
Important
• Do not plug or unplug the power cord with
wet hands or an electric shock might occur.
• Check the facsimile machine nameplate to
confirm the model code.
• Make sure that 100% is shown on the display
before you turn the power switch off or unplug
the power cord. Fax files programmed in
memory will be deleted 12 hours after you turn
the power switch off or unplug the power cord.
• Do not pull two paper trays out at the same
time. Having two paper trays filled with paper
in a fully extended position could cause the
machine to fall over.
Turn off the power switch of the machine.
Unplug the power cord of the machine
from the outlet.
3
Unplug the telephone line from the
machine.
Note
After the installation, plug the power cord of the
machine back into the outlet, turn the power switch
on, and then connect the telephone line to the
machine.
1.
Remove the tape at [A], and then remove
the tape and cardboard at [B].
2.
Pull the paper tray part out of the unit, and
then remove the tape and cardboard at [C].
3.
If necessary, adjust the paper size of the
paper tray.
Reference
T For information about changing paper size, see
"Changing the Paper Size in the Optional Paper
Tray Unit" in the Advanced Features manual.
4.
Push the paper tray in until it stops.
Continued on next page