Basic Controls - Panasonic TH-49AF1U Operating Instructions Manual

Basic Controls

Main Power On / Off button
(Back of the unit)
Operate pointing the remote control directly at
the unit's Remote Control Sensor.
Note
●
For normal use, pull out the remote control sensor
from the edge side of the main unit by operating the
lever on the rear panel. (see page 32)
●
Do not put an obstacle between the remote control
sensor of the main unit and the remote control.
●
Operate the remote control in front of the remote
control sensor or from the area where the sensor can
be seen.
●
When directly aiming the remote control at the remote
control sensor of the main unit, the distance from
the front of remote control sensor should be approx.
7 m or less. Depending on the angle, the operation
distance may be shorter.
●
Do not subject the remote control sensor of the main
unit to the direct sunlight or strong fluorescent light.
AC socket outlet
AC cord (supplied)
Remote Control Sensor /
Power Indicator
1
Connect the AC cord plug to the
Display.
(see page 18)
2
Connect the plug to the socket outlet.
Note
●
Main plug types vary between countries. The
power plug shown at left may, therefore, not be the
type fitted to your set.
●
When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the socket
outlet first.
●
The settings may not be saved if the power plug is
disconnected immediately after changing settings
with on-screen menu. Disconnect the power plug
after a enough period of time. Or, disconnect the
power plug after turning the power off with the
remote control, RS-232C control or LAN control.
3
Press the <Main Power On / Off
button> on the unit to turn the set on:
Power-On.
● Power Indicator: Green (Picture is displayed.)
●
When the power of the unit is ON, remote control
operation is possible.
■
To turn the power ON/OFF with the remote
control
Press the <Standby (ON/OFF) button> to turn the
Display on.
Power Indicator: Green (Picture is displayed.)
•
Press the <Standby (ON/OFF) button> to turn the
Display off.
When [OpenPort PLATFORM standby] is set to [Off]
Power Indicator: Red (standby)
•
When [OpenPort PLATFORM standby] is set to [On]
Power Indicator: Orange (Red/Green) (standby)
•
(About [OpenPort PLATFORM standby] settings, see
page 84.)
■
To turn the power OFF with the <Main
Power On / Off button>
●
When the power of the unit is ON (Picture is
displayed: Power indicator in green):
Pressing the <Main Power On / Off button> will
illuminate the power indicator in orange. When it goes
off, the display unit turns off.
While the indicator is illuminating in orange, the
remote control operation is ignored.
35
English