Usb Terminal Connection - Panasonic TH-49AF1U Operating Instructions Manual

USB terminal connection

Connect the USB memory (commercially available) to
use [USB media player]. (see page 105)
Also, power is supplied when a separately sold stick PC,
etc. are connected.
Note
●
A stick PC and connection cables are not supplied
with this unit.
AV IN
Stick PC
USB cable (commercially available)
HDMI extension cable (commercially available)
Pin assignments and signal names for USB Terminal
1
Pin No.
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5V/1A can be supplied to an external
device when the picture is displayed.
● If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off/on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
USB
2 3 4
Signal name
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
● Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
●
Depending on the USB memory, the access lamp
may remain blinking even when it is not being
accessed. In this case, remove the device after
switching to the input other than USB.
Also, when data cloning is running, remove the device
after the screen to notify it is finished is displayed.
(see page 109)
29
English