Panasonic TH-49AF1U Operating Instructions Manual page 98

Note
● While this function is working, the power indicator is
blinking green.
● This function also works when the power recovers
from failure or after plugging off and in again the
power cord.
●
Even if [OpenPort PLATFORM standby] (see page
84) is set to [On], when starting up in standby status
where the power indicator is off or illuminating in
red, OpenPort PLATFORM has not started yet while
operating with startup delay. Therefore, if the power
is turned off using the remote control during this time,
the unit enters the standby mode with the power
indicator illuminating in red.
Clock display
Sets to display / hide the clock.
[Off]:
Hides the clock.
[On]:
Displays the clock.
Note
●
The clock is displayed at the lower left of the screen
when <RECALL> button is pressed.
●
When current date and time is not set, the clock is
not displayed even when [Clock display] is [On]. (see
page 59)
Power on message(No activity power
off)
Sets to show/hide [No activity power off] precautions
when the power is turned on.
[On]:
The warning precautions are shown when the
power is turned on.
[Off]:
The warning precautions are not shown when the
power is turned on.
Note
● This setting is enabled only when [No activity power
off] is [Enable] (see page 84).
● The warning precautions are not shown when
OpenPort PLATFORM input is used at the time of
power ON.
98
English
Power on message(Power
management)
Sets to show/hide an information message that tells
the power has been turned off by "Power management"
function when the power is turned on.
[On]:
The information is shown when the power is turned
on.
[Off]:
The information is not shown when the power is
turned on.
Note
●
This setting is enabled only when "Power
management" function is [On] (see page 82).
POWER button lock
Sets the lock setting for the display <Main Power On /
Off button>.
[On]:
<Main Power On / Off button> operation is
disabled.
[Off]:
<Main Power On / Off button> operation is
enabled.
Note
●
This function is only for TH-55AF1U, TH-49AF1U and
TH-42AF1U.
Initialization
When both main unit buttons and remote control buttons
are disabled due to the [Button lock], [Controller user
level] and [Controller ID function] settings, set all the
values [Off] so that all the buttons are enabled again.
Press <- (Unit)> together with <RETURN>
and hold for more than 5 seconds.
[Shipping] is displayed and the lock is released when
it disappears.
Shipping
YES
● Settings for [Button lock], [Controller user level]
and [Controller ID function] will be back to [Off].
NO