Table of Contents
Advertisement
If Your Machine Does Not Operate As You
Want
When a Message Is Displayed
The following chart contains explanations of common messages. If other mes-
sages are displayed, then follow the instructions as displayed.
Note
❒ For messages not listed here, see "Troubleshooting", General Settings Guide.
Message
Cannot detect
original size.
Check original
orientation.
Check paper size.
Rotate Sort is not
available with
this image size.
It is over sta-
pling capacity.
Duplex is not
available with
this paper size.
Maximum number of
*.
sets is
Paper type or
thickness does not
match. Set the
correct paper type
or thicknes, or
change settings.
5. Troubleshooting
Causes
An irregular or custom size
original is placed. See p.12
"Sizes difficult to detect".
There is no copy paper in
the same orientation as the
originals.
An irregular paper size is
set.
A paper size for which Ro-
tate Sort is not available is
selected.
The number of sheets per
set is over the staple capac-
ity.
A paper size not available
when using the Duplex
function has been selected.
The number of copies ex-
ceeds maximum copy
quantity.
The specified paper size
differs from the actual size
of the paper loaded in the
paper tray.
Solutions
Place the original on the exposure
glass. See p.14 "Placing Originals on
the Exposure Glass".
Specify the size manually.
Do not use the Auto Reduce / En-
large function.
Place the original in the same orien-
tation as the copy paper.
Press the { { { { Start} } } } key and copying
will start on the selected paper.
Select a proper paper size. See p.161
"Sort".
Check the stapler capacity. See p.163
"Staple".
Select a proper paper size. See p.168
"Duplex".
You can change the maximum copy
quantity. See p.143 "Max. Copy
Quantity".
Press the { { { { Clear/Stop} } } } key. When
copying stops, select the appropri-
ate paper type with User Tools, or
use the appropriate paper.
123
Advertisement
Table of Contents
