Summary of Contents for Monte Carlo Fan Company 3IKR44 Series
Page 1
Owner’s Guide and Installation Manual 3IKR44XXXD Series Fan CUL Model NO. : 3IKR44XXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.25 kg 13.75 lbs Total fan weight with light...
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, FOLLOW THESE INSTRUCTIONS. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction.
Page 3
Outlet box Before you begin installing the fan, Switch Before installing this fan make sure the Use metal outlet box suitable for fan power off at Service panel and lock outlet box is properly installed to the support and use only the screws provided service disconnecting means to prevent house structure.
SAFETY CABLE INSTALLATION Hook Lag screw Safety cable Washer Lock washer Have the mounting bracket in position To prepare the fan for wiring, hang fan For Canadian installation and for USA fan and tighten the set screws. onto mounting bracket by sliding the and light kit combinations over 35 lbs, in canopy over the mounting bracket hook both flush and downrod modes the safety...
Page 5
Blade Washer Flywheel Light pan Set screw Plate on motor Insert blade into the slot on the flywheel. Loosen 2 and remove 1 preassembled Place the lead wires from fan over the Install blade by the screws and washers screw from the plate on motor. Save central hole of light pan.
Page 6
Reverse switch Setting the reverse switch in the left hand side will result in downward airflow and setting the switch in the right hand side will result in upward airflow. Note: Reverse switch must be set either way completely. If the reverse switch is set in the middle position, fan will not operate.
Page 7
Remote Controller Operation Remove the battery cover from the remote control transmitter and install batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries. Note: If not using for long periods of time, remove the batteries to prevent damage to DIM (D) remote controller, and store the remote controller away from excess heat or humidity.