Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3STR60XXXD Series Fan
cETL Model NO. : 3STR60
RETAILER NAME:
RETAILER ADDRESS:
8.1 kg
17.82 lbs
Total fan weight with light
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Monte Carlo Fan Company 3STR60 D Series
Summary of Contents for Monte Carlo Fan Company 3STR60 D Series
- Page 1 Owner’s Guide and Installation Manual 3STR60XXXD Series Fan cETL Model NO. : 3STR60 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 8.1 kg 17.82 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2019 Monte Carlo Fan Company 4/2019... - Page 3 Styrofoam and install blade on to blade screws holes on blade supporting plate. screw from the plate on motor. Save supporting plate. Install the blades with set screws screw for later use. provided. Tighten all screws securely. © 2019 Monte Carlo Fan Company 4/2019...
- Page 4 Note: In case replacement of LED light plate and twist clockwise until tight. fixture is needed. Remove the 3 black set Note: Do not install LED light kit if screws. use blanking plate. © 2019 Monte Carlo Fan Company 4/2019...
- Page 5 Warning: Cross pin and keeper pin must be not steeper than 20º. Longer downrod installed securely, failure to install them will may be necessary allowing the fan blades result in serious injury. to rotate without obstructions. © 2019 Monte Carlo Fan Company 4/2019...
- Page 6 Reinstall the screw removed in step 20 and tighten all screws securely. Attach canopy bottom cap onto canopy by aligning its notch with the screws on mounting bracket and twist clockwise till tight. © 2019 Monte Carlo Fan Company 4/2019...
-
Page 7: Transmitter Operation
Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2019 Monte Carlo Fan Company 4/2019... - Page 8 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2019 Monte Carlo Fan Company 4/2019...
-
Page 9: Troubleshooting
5.Remove light kit and check the plug connections if they are present. 6.If this fan uses remote controller, make sure dip switches are setting properly and make CAUTION: Make sure main power is turned off before entering switch housing and/or canopy. © 2019 Monte Carlo Fan Company 4/2019... - Page 10 May.2019...
Need help?
Do you have a question about the 3STR60 D Series and is the answer not in the manual?
Questions and answers