Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3 0 6 4 9 6 4
3DSTR57XXD Series Fan
ETL Model NO. : 3DSTR57(XXXXX)
RETAILER NAME:
RETAILER ADDRESS:
6.45 kgs
14.2 lbs
Total fan weight with light
Advertisement
Related Manuals for Monte Carlo Fan Company 3DSTR57 D Series
Summary of Contents for Monte Carlo Fan Company 3DSTR57 D Series
- Page 1 Owner’s Guide and Installation Manual 3DSTR57XXD Series Fan ETL Model NO. : 3DSTR57(XXXXX) Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.45 kgs 14.2 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2016 Monte Carlo Fan Company 11/2016... - Page 3 Place Yoke cover on motor assembly. Warning: Cross pin and keeper pin must be installed securely, failure to install them will result in serious injury. © 2016 Monte Carlo Fan Company 11/2016...
- Page 4 The splices after being made should be turned upward and pushed carefully up into the outlet box. © 2016 Monte Carlo Fan Company 11/2016...
- Page 5 Remove 3 set screws from light pan. Connect white wire from fan to white wire Tighten all screws securely. Save screws. from LED module and then connect blue wire from fan to blue wire from LED module. © 2016 Monte Carlo Fan Company 11/2016...
- Page 6 LED module with light pan with grooves on the lexan shade the screw holes in the light pan, and and twist clockwise until tight. reinstall the set screws removed in step © 2016 Monte Carlo Fan Company 11/2016...
-
Page 7: Transmitter Operation
Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2016 Monte Carlo Fan Company 11/2016... - Page 8 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2016 Monte Carlo Fan Company 11/2016...
-
Page 9: Troubleshooting
Trouble Shooting Warning Trouble Suggested Remedy CAUTION CAUTION CAUTION © 2016 Monte Carlo Fan Company 11/2016... - Page 10 Nov.2016...
Need help?
Do you have a question about the 3DSTR57 D Series and is the answer not in the manual?
Questions and answers