Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3IKDR52XXXD Series Fan
CUL Model NO. : 3IKDR52XXXD
RETAILER NAME:
RETAILER ADDRESS:
7.35 kg
16.17 lbs
Total fan weight with light
Advertisement
Related Manuals for Monte Carlo Fan Company 3IKDR52 D Series
Summary of Contents for Monte Carlo Fan Company 3IKDR52 D Series
- Page 1 Owner’s Guide and Installation Manual 3IKDR52XXXD Series Fan CUL Model NO. : 3IKDR52XXXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 7.35 kg 16.17 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction. - Page 3 Before you begin installing the fan, Switch Before installing this fan make sure the Use metal outlet box suitable for fan power off at Service panel and lock outlet box is properly installed to the support and use only the screws provided service disconnecting means to prevent house structure.
- Page 4 SAFETY CABLE INSTALLATION Lag screw Cross pin Safety cable Slot Keeper pin Washer Lock washer Slip downrod into motor housing yoke, Install ball end of downrod into mounting For Canadian installation and for USA fan aligning holes and install cross pin and bracket opening.
- Page 5 Light pan Blade Plate on motor Insert blade into the slot on flywheel. Loosen 2 and remove 1 preassembled Place the lead wires from fan over the Install blade with screws and washers screw from the plate on motor. Save central hole of light pan provided, aligning each of the holes as screw for later use.
- Page 6 Reverse switch Setting the reverse switch on the left hand side will result in downward airflow and setting the switch on the right hand side will result in upward airflow. Note: Reverse switch must be set either way completely. If the reverse switch is set in the middle position, fan will not operate.
-
Page 7: Learn Mode
Remote Controller Operation Remove the battery cover from the remote control transmitter and install batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries. Note: If not using for long periods of time, remove the batteries to prevent damage to DIM (D) remote controller, and store the remote controller away from excess heat or humidity. - Page 8 Install Transmitter wall mount cradle with 2 screws provided. Useful tips: The remote transmitter can be removed by pressing it upward from the lower half. The remote transmitter can be held on magnetic metal materials by a magnet built in the transmitter. Wall mount cradle User Tips 1.
-
Page 9: Troubleshooting
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel. - Page 10 Nov.2022...