Advertisement
7
Have the mounting bracket in position
and tighten the set screws.
10
Receiver
Make wiring connections using wire connectors provided as indicated above. White from
fan to White from remote marked to motor N. Black from fan to Black from remote marked
to motor L. Blue from fan to Blue from remote marked FOR LIGHT. White
house to White from remote marked AC IN N. Black
remote marked AC IN L. Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Fix the receiver with the clip on the mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet box. The splices after being
made should be turned upward and pushed carefully up into the outlet box.
Caution: The installation has to be complete before operate the fan.
© 2021 Monte Carlo Fan Collections
8
To prepare the fan for wiring, hang fan
onto mounting bracket by sliding the
canopy over the mounting bracket hook
(Use one of non-slotted holes on the
rim of the canopy).
Wall switch
White
Blue
Black
Receiver
(Live)
Hook
White
Black
Power source
Green/Ground
Green/Ground
(Neutral)
from
from house to Black from
4
SAFETY CABLE INSTALLATION
9
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 3" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
11
Lift fan to mounting bracket, aligning the
"L" shape holes on canopy with the
screws on the mounting bracket. Turn the
fan clockwise to lock in position. Install
the other 2 canopy mounting set screws
that are removed in the installation step 4
and tighten all screws securely.
Install decorative ring. Align the head of
set screws on the canopy with the groove
in the decorative ring and twist clockwise
till tight.
11/2021
Advertisement
