When Copying Onto Ohp Transparencies Or Thick Paper - Gestetner 3355 User Manual

Copying
Note
If you do not register the non-standard size, go to step F.
Only one non-standard size can be stored.
To recall the non-standard size stored, press the [Recall] key.
If you do not register the non-standard size, the size you set is deleted
when modes are cleared.
2
F Press the [OK] key.
D
Set your originals, then press the {Start} key.
E
When your copy job is finished, press the {Clear Modes/Energy Saver} key to
clear the settings.

When Copying onto OHP Transparencies or Thick Paper

To make copies onto OHP transparencies or thick paper, you need to specify the
paper type.
Limitation
When you select "OHP" or "Thick Paper", copy paper is delivered face up
even if you have set the "Face-Up/Down Selection in Bypass Mode" setting
to "Face Down Exit". See "Face-Up/Down Selection in Bypass Mode" in
P.331 "Count Manager".
Note
Select [Thick Paper] if the paper weight is more than 105g/m
A
Open the bypass tray, and adjust the guides to the paper size.
Important
If the guides are not flush with the copy paper, a skew image or paper mis-
feeds might occur.
B
Lightly insert the OHP transparencies or thick paper face up until the beep-
er sounds.
The k indicator on the display automatically goes on.
Note
When you set an OHP transparency, make sure that its front and back faces
are properly positioned.
To avoid paper misfeeds, fan the paper before setting it in the tray.
C
Press the {#} key.
76
2
, 28 lb. Bond.