Gestetner 3355 User Manual page 22

In Connect Copy mode, you cannot use the Interrupt Copy function when
memory on the sub-unit is full.
In Connect Copy mode, after finishing the interrupt copy job on the sub-unit,
be sure to exit Interrupt mode on the sub-unit. When you exit Interrupt mode,
the two machines automatically share the rest of the connect copy job.
In Connect Copy mode, if the connect copy job is finished before finishing the
interrupt copy job on the sub-unit, be sure to exit Interrupt mode on the sub-
unit. If you do not exit Interrupt mode, the next connect copy job cannot be
started.
To interrupt an original being fed
A
Press the {Interrupt} key.
The Interrupt indicator goes on and scanning stops.
B
Remove the originals that were being copied and set the originals you wish
to copy.
C
Press the {Start} key.
The machine starts making your copies.
D
When your copy job is finished, remove your originals and copies.
E
Press the {Interrupt} key again.
The Interrupt indicator goes off.
F
When the display prompts you to, replace the originals that were being
copied before.
G
Press the {Start} key.
The previous copy job settings will be restored and the machine will continue
copying from where it left off.
To interrupt copying after all originals have been fed
A
Press the {Interrupt} key.
The Interrupt indicator goes on.
Note
Copying will not stop yet.
B
Set your original.
C
Press the {Start} key.
The machine stops the original job and starts copying your original.
Other Functions
2
89