Making Adjustments And Selections - Panasonic PT-FX500 Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector
[STANDBY MODE]
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (time zone)
Set [TIME ZONE] according to the country or region where the projector is used.
After the initial setting completed, you can change the setting from the [PROJECTOR SETUP] menu → [DATE
AND TIME]. The current settings are displayed in [LOCAL DATE] and [LOCAL TIME].
1) Press as to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Note
f By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.
Initial setting (date and time)
Set the local date and time. After the initial setting is completed, you can change the setting from the [PROJECTOR
SETUP] menu → [DATE AND TIME].
To set the date and time automatically, refer to "Setting the date and time automatically" ( x page 97).
1) Press as to select an item.
2) Press qw to switch the setting.
3) Press the <ENTER> button.
f Confirm the setting value and complete the initial setting.

Making adjustments and selections

It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
44 - ENGLISH
Set the operation mode during standby. The default setting is [NORMAL], you
can use the network function during standby. If you want to reduce the power
consumption, it can be set to [ECO]. After the initial setting is completed,
you can change the setting from the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [STANDBY MODE].
89