Panasonic PT-FX500 Operating Instructions Manual page 109

f LOGIN PASSWORD
f PROJECTOR NAME
f SSID
f IP ADDRESS(WIRELESS)
f IP ADDRESS(WIRED)
Attention
f Please do not move or transport the projector while the wireless module is attached. Doing so may cause the wireless module to be
damaged.
f The indicator of the wireless module will be off when the projector is in standby mode, it will light in blue when the power is turned on and it
will blink in blue during wireless communicating.
Please do not remove the wireless module while the indicator is blinking.
f When the power of the projector is turned on and the indicator of the wireless module is not lighting/blinking, please insert the wireless
module to the <WIRELESS> terminal again.
f The [IP ADDRESS (WIRELESS)] is displayed after the power is turned on, please connect network to the projector.
Note
f Wireless LAN and wired LAN cannot be used in the same segment.
f The settings of the wireless module are as follows. You can access the projector from the web browser to set the values of [SSID], [CHANNEL]
and [ENCRYPTION].
Computer setting
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f Please make the network settings for the computer and the projector according to your system
administrator.
3) Connect to the network that has been set in the projector.
f If you use a computer, click on the task tray
as the [SSID] that has been set in the projector.
Note
f If you use any wireless LAN connection utility that meets the OS standard, follow the operation instruction of the utility to connect it.
Chapter 5 Operation of Function — Network connections
[SSID]
[CHANNEL]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[ENCRYPTION]
Network input idle screen
LOGIN PASSWORD : 5678
PROJECTOR NAME : Name1234
SSID : Panasonic Projector
IP ADDRESS(WIRELESS) : 172.28.120.1
IP ADDRESS(WIRED) : 192.168.1.100
NetworkDisplay
1
172.28.120.1
255.255.255.0
0.0.0.0
Disable
(bottom right of the computer), then select the same name
ENGLISH - 109