Parts For Ceiling Mount (Optional); Projected Image And Throw Distance - Panasonic PT-FX500 Operating Instructions Manual

Parts for ceiling mount (optional)

The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings)) and ET-PKE300B (Projector Mount Bracket).
f Be sure to use the Ceiling Mount Bracket specified for this projector.
f Refer to the Installation Instructions supplied with the Ceiling Mount Bracket when installing the projector with
the bracket.
Attention
f To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualified
technician.

Projected image and throw distance

Refer to the screen size and projection distances to install the projector. Image size and image position can be
adjusted in accordance with the screen size and screen position.
Note
f This illustration is represented on the assumption that the size and position of the projection screen are matched to fill the screen.
L (LW/LT)
*1
SH
SW
H
SD
*1 LW: Minimum projection distance
LT: Maximum projection distance
Attention
f Before setting up, read "Precautions for use" ( x page 17).
[SCREEN ADJUSTMENT] projection range
[VERTICAL KEYSTONE] (viewed from the side)
Screen
32 - ENGLISH
Chapter 2 Getting Started — Setting up
Projected image
SW
Projection distance
Projected image height
Projected image width
Distance from the lens center to the bottom edge of the projected image
(When setting on a desk/floor, if the bottom edge of the projected image is below the lens center, the value
of H is positive.)
Projected image size
Screen
L (LW/LT)
L (LW/LT)
Screen
[HORIZONTAL KEYSTONE] (viewed from above)
Screen
(Unit: m)