Trusted Computing (Available When A Tpm Device Is Installed And Detected By The Bios); Configuration; Security Device Support; Tpm State - Supero X10SRW-F User Manual

Table of Contents

Bits Per Second

This item sets the transmission speed for a serial port used in Console Redirec-

tion. Make sure that the same speed is used in the host computer and the client

computer. A lower transmission speed may be required for long and busy lines.

The options are 9600, 19200, 57600, and 115200 (bits per second).

Flow Control

Use this item to set the flow control for Console Redirection to prevent data

loss caused by buffer overflow. Send a "Stop" signal to stop sending data when

the receiving buffer is full. Send a "Start" signal to start sending data when

the receiving buffer is empty. The options are None, Hardware RTS/CTS, and

Software Xon/Xoff.

The setting for each these features is displayed:

Data Bits, Parity, Stop Bits

Trusted Computing (Available when a TPM device is

installed and detected by the BIOS)

If this feature and the TPM jumper on the motherboard are both set to Enabled,

onboard security devices will be enabled for TPM support to enhance data integrity

and network security. Please reboot the system for a change on this setting to take

effect. The options are Enabled and Disabled.

Select Enabled to use TPM (Trusted Platform Module) settings to enhance system

data security. Please reboot your system for any change on the TPM state to take

effect. The options are Disabled and Enabled.

Use this item to schedule a TPM-related operation to be performed by a security

device for system data integrity. Your system will reboot to carry out a pending TPM

operation. The options are 0, Enable Take Ownership, Disable Take Ownership,

and TPM Clear.

Note: Your system will reboot to carry out a pending TPM operation.

This item displays the status of the TPM support on this motherboard.

4-31

Chapter 4: AMI BIOS

Table of Contents