Turning The Projector On/Off; Turning The Projector On; Turning The Power Off; Projector Into Standby Mode - Sharp Conference Series XG-PH80W-N Operation Manual

Turning the Projector On/Off

Turning the Projector On

Note that the connections to external
equipment and power outlet should be
done before performing the operations
written below. (See pages
Remove the lens cap. Then switch the
MAIN POWER switch on the projector
to "ON" and, after the POWER
indicator has turned red, press
STANDBY/ON on the projector or on
the remote control.
• The POWER indicator illuminates green.
• After the LAMP indicator illuminates, the projector
is ready to start operation.
Note
• About the LAMP Indicator
The LAMP indicator illuminates to indicate the
status of the lamp. (See page
Green or orange: The lamp is on.
Blinking in green or orange: The lamp is
warming up.
Red: The lamp is shut down abnormally
or the lamp should be replaced.
• When you switch on the projector, a slight
fl ickering of the image may be experienced
within the fi rst minute after the lamp has been
illuminated. This is normal operation as the
lamp's control circuitry is stabilizing the lamp
output characteristics. It should not be
regarded as faulty operation.
• If the projector is put into Standby mode and
immediately turned on again, the lamp may
take some time to start projection.
• When Security Lock is set, the password
input box appears. To cancel the password
setting, input the password that you have
already set. See page
Turning the Power Off (Putting
the Projector into Standby Mode)
Press STANDBY/ON on the projector or
on the remote control, then press that
button again while the confi rmation
message is displayed, to put the

projector into Standby mode.

• The projector cannot be turned on while cooling.
28
21 to 25.)
64 for details.)
51 for details.
Info
• When "Auto Restart" is set to "On":
If the power cord is unplugged from the outlet
or the breaker switch is turned off when the
projector is on, then the projector
automatically turns on when the power cord
is plugged into the AC outlet or the breaker
switch is turned on. (See page 52.)
• English is the factory default language. If you
want to change the on-screen display to
another language, change the language
according to the procedure on page 49.
On-screen display (confi rmation message)
Enter STANDBY Mode?
Yes : Press Again
No : Please Wait
Info
Direct Power Off function:
• You can unplug the power cord or switch the
MAIN POWER switch to "OFF" even if the
cooling fan is still running.
• If you turn the power back on in the cases
shown below, the lamp will take a longer
time to light up than usual:
– When the power cord is unplugged during
operation
– When the MAIN POWER switch is turned
"OFF" during operation
STANDBY/ON button
LAMP 1 indicator
LAMP 2 indicator
POWER indicator
STANDBY/ON
button