Turning The Projector On/Off - Sharp AN-K2LP Operation Manual

Table of Contents

Advertisement

Turning the Projector On/Off

Connecting the Power Cord
Plug the supplied power cord into the
AC socket.
Turning the Projector On
Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 19-27.)
Remove the lens cap and press
projector or
on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green:The lamp is ready.
Blinking green: The lamp is warming up
or shutting down.
Red: The lamp is shut down abnormally or
the lamp should be replaced.
• When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp's control
circuitry is stabilising the lamp output charac-
teristics. This does not indicate malfunction.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Turning the Power Off
ting the Projector into Standby Mode)
1
Press
on the projector or
on the remote control, then press
that button again while the confir-
mation message is displayed, to
put the projector into standby
mode.
2
Unplug the power cord from the AC
outlet after the cooling fan stops.
-28
Supplied
accessory
Info
• English is the factory preset language. If you want to
on the
change the on-screen display to another language,
change the language according to the procedure on
page 52.
ON button
STANDBY
button
(Put-
▼On-screen Display
Info
• Do not unplug the power cord during projection or cool-
ing fan operation. The cooling fan in this projector contin-
ues to run for about 90 seconds after the projector enters
the standby mode. This can cause damage due to rise in
internal temperature, as the cooling fan also stops.
ON button
STANDBY
button
Power cord
(6' (1.8 m))
Power indicator
Lamp
indicator
Lens cap

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv-z2000Ah-57201Dt400Eip-1500t

Table of Contents