Turning The Projector On/Off; Turning The Projector On; Turning The Power Off (Putting The Projector Into Standby Mode) - Sharp Notevision XR-20XA Operation Manual

Turning the Projector On/Off

Turning the Projector on

Note that the connections to external equip-
ment and power outlet should be done be-
fore performing the operations written be-
low. (See pages 23
Remove the lens cap and press
S STANDBY/ON on the projector or
fON on the remote control.
• When System Lock is set, the keycode input box
appears. To cancel the keycode setting, input the
keycode that you have already set. See page
for details.
Note
• About the Lamp Indicator
The lamp indicator illuminates to indicate the status of the
lamp.
Green: The lamp is on.
Blinking in green: The lamp is warming up or shut-
ting down.
Red: The lamp is shut down abnormally or the
lamp should be replaced.
• When switching on the projector, a slight flickering of the
image may be experienced within the first minute after the
lamp has been illuminated. This is normal operation as the
lamp's control circuitry is stabilising the lamp output char-
acteristics. It should not be regarded as faulty operation.
• If the projector is put into standby mode and immediately
turned on again, the lamp may take some time to start pro-
jection.
Turning the Power off (Putting
the Projector into Standby Mode)
Press SSTANDBY/ON on the pro-
1
jector or eSTANDBY on the re-
mote control, then press that but-
ton again while the confirmation
message is displayed, to put the
projector into standby mode.
Unplug the power cord from the AC
2
outlet after the cooling fan stops.
• The power indicator on the projector
blinks in green while cooling.
• The power indicator changes to red when
the projector finishes cooling.
to 26.)
44
Info
• English is the factory default language. If you
want to change the on-screen display to another
language, change the language according to
the procedure on page 42.
On-screen Display (confirmation message)
R
Info
• Do not unplug the power cord during projection
or cooling fan operation. This can cause dam-
age due to rise in internal temperature, as the
cooling fan also stops.
Lamp indicator
Power indicator
STANDBY/ON button
STANDBY
button
ON button
27