How To Replace The Lamp - Epson EB-590WT User Manual

Replacing Consumables
Attention
• The lamp replacement message is set to appear after the following time
periods in order to maintain the initial brightness and quality of the projected
images.
For EB-595Wi/EB-585Wi/EB-585W/EB-580:
When Power Consumption is set to Normal: About 3900 hours
When Power Consumption is set to ECO: About 5900 hours
For EB-575Wi/EB-575W/EB-570:
When Power Consumption is set to Normal: About 4900 hours
When Power Consumption is set to ECO: About 9900 hours
s ECO - Power Consumption
• If you continue to use the lamp after the replacement period has passed, the
possibility that the lamp may blow increases. When the lamp replacement
message is displayed, replace the lamp with a new one as soon as possible,
even if it is still working.
• Do not repeatedly turn off the power and immediately back on. Turning the
power on and off frequently may shorten the lamp's operating life.
• Depending on the individual characteristics of the lamp and the way it has
been used, the lamp may become darker or stop working before the message
is displayed. You should always have a spare lamp unit ready in case it is
needed.
• We recommend the use of genuine Epson option lamps. The use of non-
genuine lamps may affect projection quality and safety. Any damage or
malfunction caused by the use of non-genuine lamps may not be covered by
Epson's warranty.
a
We recommend that you clean the air filter whenever you replace the
lamp.
s "Cleaning the Air Filter"
p.144
p.172

How to Replace the Lamp

The lamp can be replaced even when the projector is suspended from a wall
or ceiling.
Warning
• When replacing the lamp because it has stopped working, there is a
possibility that the lamp may be cracked. When replacing the lamp of a
projector that has been installed on a wall or ceiling, assume that the lamp is
cracked and stand to the side of the lamp cover, not underneath it. Also,
remove the lamp cover gently. Be careful when removing the lamp cover as
shards of glass may fall out and could cause an injury. If any shards of glass
get into your eyes or mouth, contact your local physician immediately.
• Never disassemble or modify a lamp. If a modified or disassembled lamp is
installed in the projector and used, it could cause a fire, electric shock, or an
accident.
Caution
Wait until the lamp has cooled down sufficiently before removing the lamp
cover. If the lamp is still hot, burns or other injuries may result. It takes
approximately one hour after the power has been turned off for the lamp to
sufficiently cool down.
a
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cord.
176