Esc/Vp21 Commands; Command List; Cable Layouts - Epson EB-590WT User Manual

Monitoring and Controlling
a
• SNMP should be managed by a network administrator or someone
who is familiar with the network.
• To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
• The SNMP Agent for this projector complies with version 1
(SNMPv1).
• The managing function using SNMP cannot be used via wireless
LAN in Quick connection mode.
• Up to two destination IP addresses can be saved.

ESC/VP21 Commands

You can control the projector from an external device using ESC/VP21.

Command List

When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Item
Power ON/OFF On
Off
Signal selection Computer1
Command
PWR ON
PWR OFF
Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14
Item
Computer2
HDMI1/MHL
HDMI2
Video
S-Video
USB Display
USB
LAN
A/V Mute ON/OFF On
Off
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
For more details, contact your local dealer or the nearest address provided
in the Epson Projector Contact List.
Epson Projector Contact List
s

Cable Layouts

Serial Connection
• Connector shape: D-Sub 9-pin (male)
118
Command
Auto SOURCE 2F
RGB SOURCE 21
Component SOURCE 24
SOURCE 30
SOURCE A0
SOURCE 41
SOURCE 42
SOURCE 51
SOURCE 52
SOURCE 53
MUTE ON
MUTE OFF