Table of Contents
Advertisement
Chapter 3 Basic Operations - Basic operations by using the remote control
Basic operations by using the remote control
Using the AUTO SETUP function
The automatic setup function can be used to automatically adjust the resolution, clock phase, and image position when
analog RGB signals consisting of bitmap images such as computer signals are being input. Supplying images with bright
white borders at the edges and high-contrast black and white characters is recommended when the system is in automatic
adjustment mode.
Avoid supplying images that include halftones or gradation, such as photographs and computer graphics.
button
1)
Press the <AUTO SETUP/CANCEL> button on the remote control.
Note
f The [CLOCK PHASE] may shift even if it has completed without any incident. In such cases, adjust the [POSITION] menu →
[CLOCK PHASE] (x page 67).
f Automatic adjustment may not work depending on the model of the computer and the input signal.
f Images may be disrupted for a few seconds during automatic adjustment, but it is not a malfunction.
f If you press any button on the remote control during the automatic adjustment, the automatic adjustment will be canceled.
f If the automatic setup function is used while moving images are being input, the adjustment may not be performed properly
even for an RGB signal that can use automatic setup.
Using the KEYSTONE button
You can correct the trapezoidal distortion that occurs when the projector is installed tilted or when the screen is tilted.
button
1)
Press the <KEYSTONE> button to select [KEYSTONE] or press the <KEYSTONE> button again to
select [CORNER CORRECTION].
f The [KEYSTONE] or [CORNER CORRECTION] individual adjustment screen is displayed.
2)
Press asqw to adjust the item.
Note
f For more details, refer to the [POSITION] menu → [KEYSTONE] (x page 65).
Controlling the volume of the speaker
You can control the volume of the projector's speaker or audio output.
ENGLISH - 49
Advertisement
Chapters
Table of Contents
