Powering On/Off; Connecting The Power Cord; Power Indicator - Panasonic PT-VX425N Operating Instructions Manual

Powering on/off

Connecting the power cord

Make sure that the supplied power cord is securely fixed to the projector body to prevent it from being removed
easily.
For details of power cord handling, refer to "Read this first!" (x page 2).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction (until you hear the side tabs click in
place).
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.

Power indicator

The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Confirm the status of the power indicator
<ON(G)/STANDBY(R)> before operating the projector.
Indicator status
Off
Lit
Red
Blinking
Orange Lit
Chapter 3 Basic Operations - Powering on/off
Power indicator <ON(G)/STANDBY(R)>
The power cord is unplugged.
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x [STANDBY MODE] is set to [ECO].
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x [STANDBY MODE] is set to [NETWORK].*
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x [STANDBY MODE] is set to [NORMAL].*
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
Status
1
2
ENGLISH - 41