Setting Thread Wiping - Brother S-7100A-403 Instruction Manual

4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

4-4-3. Setting thread wiping

The initial setting value is ON.
If the thread wiper is connected but thread wiping is not to be carried out, change this setting to OFF.
1
Activating setting mode
(While pressing the thread trimming disable/F1 key, turn on the
power switch.)
2
Selecting "WiP" (thread wiping)
(Setting item)
(Press four times)
3
Enabling and disabling thread wiping
4
5
23
(Setting value)
(Setting item)
(Setting item)
・ When the D
setting is displayed.
・ When the C
previous setting is displayed.
・ When the D
display will appear.
・ When the C
display will appear.
Thread wiping enabled
...
Thread wiping disabled
...
NOTE:
If the SEL key (1) is pressed once more, the
ABCD indicator will switch off and the
display will return to the setting item.
The setting will be stored and the display will
return to the setting item.
Setting mode will be exited and normal
operation will be possible.
S-7100A
0517D
key is pressed, the next
key is pressed, the
0524D
key is pressed, the "on"
key is pressed, the "oFF"
0522D
0525D
0520D