Setting The Counters; Lower Thread Counter - Brother S-7100A-403 Instruction Manual

4-3. Setting the counters

The lower thread counter, thread trimming counter and needle replacement counter can be displayed.
The three counters can be operated at the same time.

4-3-1. Lower thread counter

The lower thread counter can be used to let you know approximately how much lower thread is remaining.
<Setting the lower thread counter initial value>
1
Press the SEL key so that the COUNT indicator is illuminated.
2
Press the ENTER key for 2 seconds or more, and then press the
C or D key to set the initial value.
(Press for 2 seconds or more
<Lower thread counter operation>
・ The lower thread counter is reduced by 1 from the initial setting value each time the sewing machine sews 10 stitches,
and a warning is given when the counter goes below"0".
・ Sewing will be possible even after the treadle is returned to the neutral position and the sewing machine stops. However,
after the treadle has been depressed backward and thread trimming has been carried out, sewing using the treadle will no
longer be possible.
If the treadle is depressed at this time, " Ent" will appear in the display. When the treadle is returned to the neutral position,
the display will return to the current counter display.
・ If the ENTER key is pressed while the lower thread counter is displayed, the COUNT indicator will change to illuminated
and sewing can then be carried out using the treadle.
If the ENTER key is pressed again for 2 seconds or more, the counter display will return to the initial value and counting
from the initial value will be possible.
4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
.
)
・ The lower thread counter value will appear
in the four columns of the display.
・ When the D
increases by 1.
・ When the C
decreases by 1.
NOTE:
・ The setting range is from 0 to 9999.
・ If an initial value of "0" is set, the lower
thread counter will not operate.
When the warning occurs, the COUNT indicator flashes,
and a buzzer sounds for 5 seconds.
S-7100A
0509D
key is pressed, the setting
key is pressed, the setting
0510D
0511D
18