Table of Contents
Advertisement
User's Guide
Maintenance Box Code
Epson recommends the use of a genuine Epson maintenance box.
Maintenance box code: T6716
Important:
c
Once a maintenance box has been installed in a printer it cannot be used with other printers.
Maintenance Box Handling Precautions
Read the following instructions and Important Safety Instructions (paper manual) before replacing the
maintenance box.
❏ Do not touch the green chip on the side of the maintenance box. Doing so may prevent normal operation and
printing.
❏ Do not tilt the used maintenance box until after it is sealed in the plastic bag; otherwise ink may leak.
❏ Keep the maintenance box out of direct sunlight.
❏ Do not replace the maintenance box during printing; otherwise, ink may leak.
❏ Do not reuse a maintenance box which has been removed and left detached for a long period. Ink inside the box
will have solidified and no more ink can be absorbed.
Replacing a Maintenance Box
In some print cycles a very small amount of surplus ink may be collected in the maintenance box. To prevent ink
leakage from the maintenance box, the printer is designed to stop printing when the absorbing capacity of the
maintenance box has reached its limit. Whether and how often this is required will vary according to the number
of pages you print, the type of material that you print and the number of cleaning cycles that the printer performs.
When a message is displayed prompting you to replace the maintenance box, refer to the animations displayed on
the control panel. The need for replacement of the box does not mean that your printer has ceased to operate in
accordance with its specifications. The Epson warranty does not cover the cost of this replacement. It is a user-
serviceable part.
Note:
When it is full, you cannot print until the maintenance box is replaced to avoid ink leakage.
Related Information
"Maintenance Box Handling Precautions" on page 78
&
Replacing an Ink Supply Unit and Other Consumables
78
Advertisement
Table of Contents
