Table of Contents
Advertisement
Technical data
Dimensions (W X L X H):
Mains voltage:
Power consumption:
Air flow rate:
Temperature range:
Accuracy:
Vacuum:
Mains fuse:
Protection class:
2. Placing in operation
Place the hand-piece, with the hot air nozzle installed, in the AKT30 safety stand. (The device
cannot be placed in operation without the safety stand or optional WBH 3000S Circuit Board
Holder.) Plug cable from safety stand or optional WBH 3000S Circuit Board Holder (proximity
switch), into socket (17). Check whether the mains voltage matches the information on the rating
plate. If the mains voltage is correct, connect the controller to the mains. When the device is
switched on, the device name "WHA 3000" and the software "Version" are displayed briefly. The
electronics then switch automatically to the default setting (Manual operating mode).
2.1 Manual operating mode
Information on display (1)
In the Manual operating mode the parameters for the nozzle temperature, air flow rate and switching
on or off the pre-heating can be set.
Select the parameter by pressing the Control Key:
•
TEMP (7):
•
AIR (6):
•
TIME/
PREHEAT (5):
After selection, the setting can be changed using the UP (2) or DOWN (3) Control Keys. Keeping the
Control Key depressed, rapidly changes the value.
The hot air and the nozzle vacuum are activated:
Directly on the Control Panel:
240 (9.44) X 270 (10.63) X 170 (6.69) mm (inch)
230 V (120 V) AC
600 W
5 – 50 l/min
50°C –550°C (150°F – 999°F)
+/- 30°C (+/- 54°F)
- 0.6 bar
230 V / T6.3A (120 V / T8 A)
1 (Control Unit and Hand-Piece are hard grounded)
TEMP
350°C
Nozzle
Temp.
in °C/°F
Nozzle temperature in °C/°F
(see Switching Temperature Conversion page 11)
Air flow rate in l/min
Switch ON - OFF the nozzle pre-heating (standby) at 200°C/392°F with 5 l/min
airflow
Hot air START/STOP Control Key (10), Vacuum VAC Control
Key (11)
AIR
PREHEAT
25 l
OFF
Air
Nozzle
Flow Rate
Pre-Heating
in l/min
ON/OFF
Page 6 of 14
Advertisement
Table of Contents
