Setting Temperature Profile - Weller WHA3000PN Operating Instructions Manual

Information on the display (1)
Nozzle
Pre-Heater
Nozzle
Nozzle or
bottom heater symbol
Temperature of the nozzle or
bottom heater (with WHP 3000)
Air flow rate in l/min
Time remaining for the
temperature profile step in sec.

2.3 Setting temperature profile

Select the parameters by pressing the Control Key:
•
TEMP (7):
Symbol for nozzle or bottom heater indicates which temperature is displayed.
•
AIR (6):
•
TIME/
PREHEAT (5) :
The active value is marked on the display and can be changed using the UP / DOWN (2) / (3)
Control Keys. Keeping the Control Key depressed, rapidly changes the value.
TEMP
210°C
300°C
210°C
Depressed Once
Depressed Twice
Repeat for Steps 1-3
Depressed Once:
Repeat for Steps 1-3
Depressed Once:
Repeat for Steps 1-3
AIR TIME
40 l
25 l
30 l
: Nozzle temperature during the first step
Temperature of the bottom heater during the first
step
(only with WHP 3000)
Air flow rate in l/min during the first step
time remaining in the first step
100s
step 1
step 2
50s
step 3
15s
Page 8 of 14