Cleaning And Disinfection; Explanation Of Symbols - Barco MDSC-2326 DDIH User Manual

FCC Class A (valid for MDSC-2326 MNAH version)
This equipment has been tested and found to comply with the limits of a class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Canadian notice
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
6.5

Cleaning and disinfection

Instructions
• Be sure to unplug the power cord from the mains when cleaning your LCD monitor.
• Take care not to scratch the front surface with any hard or abrasive material.
• Dust, finger marks, grease etc. can be removed with a soft damp cloth (a small amount of mild deter-
gent can be used on the damp cloth).
• Wipe off water drop immediately.
Possible cleaning solutions
• 70 percent isopropyl alcohol
• 1.6 percent aqueous ammonia
• Cidex® (2.4 percent glutaraldehyde solution)
• Sodium hypochlorite (bleach) 10 percent
• "Green soap" (USP)
• 0.5 percent Chiorhexidine in 70 percent isopropyl alcohol.
• Like Cleansafe® optical cleaning liquid
6.6

Explanation of symbols

Symbols on the device
On the device or power supply, you may find the following symbols (nonrestrictive list):
K5902135 (451920612561) MDSC-2326 28/02/2017
Indicates the device meets the requirements of the applicable EC directives.
Indicates compliance with Part 15 of the FCC rules (Class A or Class B)
Indicates the device is approved according to the UL Recognition regulations
6. Important information
57