Table of Contents
Advertisement
Note
f Contact the manufacturer of the access point (radio repeating device) in use if wireless LAN connection cannot be established via the
access point even after "Setting for projector" (x page 103) is executed.
f If you use EAP, settings of the projector need to be configured according to the RADIUS server settings. Consult your network administrator
for the RADIUS server settings.
f If you use EAP together with an access point where SSID broadcast is disabled, select [WPA-EAP] or [WPA2-EAP] for authentication
method even when the authentication of the access point is WPA-EAP/WPA2-EAP.
7)
Press qw to select [NEXT], and press the <ENTER> button.
f The [WIRELESS LAN] ([USER]) screen (2/2) is displayed.
8)
Press as to select each item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
Note
f When you use a DHCP server, confirm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, default gateway, and DNS server address.
f Wired LAN and wireless LAN cannot be used in the same segment.
9)
Press as to select [STORE], and press the <ENTER> button.
f Press as to select [RETURN] and then press the <ENTER> button to return to the [WIRELESS LAN]
([USER]) screen (1/2).
f When the SSID with a key icon is selected, [RETURN] will not be displayed.
10) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The following settings are configured for [USER] as the factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]
[SSID]
[AUTHENTICATION]
[ENCRYPTION]
[NETWORK CONTROL]
Set up the control method of the network.
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[PJLink CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[STORE]
80 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
Enter the IP address when not using a DHCP server.
Enter the subnet mask when not using a DHCP server.
Enter the default gateway address when not using a DHCP server.
Enter the primary DNS server address when not using a DHCP server.
Enter the secondary DNS server address when not using a DHCP server.
OFF
192.168.11.100
255.255.255.0
192.168.11.1
(Blank)
Panasonic Projector
Open
None
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] when you control the projector using control commands. Refer to "Control commands via
LAN" (x page 135).
Set the port number used for command control.
Set to [ON] when you control the projector using Crestron Connected
Save the current network control settings.
of Crestron Electronics, Inc.
TM
Advertisement
Table of Contents
