Table of Contents
Advertisement
Appendix F
Fuse Installation
Two options are available for fusing the SR860–North Americal style single fuse, and
metric dual fuse installation. The fuse holder is reversible to accommodate both styles.
The following steps describe how to install or replace the fuse(s):
1. Disconnect and remove the power cord.
2. Insert a small screwdriver at the point "X" as shown
3. Gently lift the entire door back, away from the rear panel of the SR860. Lift
4. When the fuse holder is installed in the single fuse (North American) position,
away approximately 0.25" (6 mm). Once lifted, the door will pivot on its hinges
to expose the fuse holder.
apply a screwdriver or small needle nose plyers as shown and gently lift out. Use
a tool as shown, do not use fingers.
Fuse Installation and ac Line Select
SR860 DSP Lock-in Amplifier
179
Advertisement
Table of Contents
