Table of Contents
Advertisement
90
Operation
The SR860 has 4 Aux Outputs on the rear panel. Use this screen to set their levels.
Touch one of the {Out n} buttons to select an aux output, then use the keypad to enter a
value. The <Cursor> knob will also adjust the output value in this screen.
[Calc/system]
Press [Calc/system] briefly to display the calculator screen.
This is an RPN calculator where the operator follows all of its operands. For more
information, ask your friends or check the internet.
nd
The {2
Note that the reference phase, frequency and amplitude can be copied in and out of the
calculator.
System Menu
Press and hold [Calc/system] to display the system menu. The system menu is used to set
non-measurement parameters such computer interface configurations, file names, clock
setup and more. Use the {↑} and {↓} buttons next to the category list to move up and
down through the category list (General – Files – Ethernet ...). Touch a {category} to
show its settings.
SR860 DSP Lock-in Amplifier
} button switches the functions of the operator keys.
Chapter 3
Advertisement
Table of Contents
