Roller And Castor Wheels Adjustment - Major Swift S2 MJ71-190 Operator's Manual & Parts List

Roller and Castor wheels adjustment

In order to achieve desired cutting height, castor wheels and roller should be adjusted.
Castor wheels (optional)
To adjust the height of front wheels lift up the
machine and:
1. Unscrew and remove Bolt A;
2. Slide down the Castor Yoke B and remove
it;
3. Depending on the desired cutting height
place Spacers C above or below Castor
Arm D.
4. When adjustment is complete, relocate
Castor Yoke B and secure it with Bolt A.
5. Repeat this procedure for the other wheel.
A
D
Scraper bar
In order for a scraper bar to function properly, it
should be kept tensioned. To tension the scraper
bar (1) tighten up nuts (2) at both ends of the roller
(3). Locate the scraper bar bracket (4) in a desired
position by loosening/tightening bracket nut (5).
Roller
To adjust the height of the roller follow this procedure at
both sides of the roller:
1. Loosen Bolts B and C (Note: You do not have to remove
these bolts, half of the turn will suffice to allow movement);
2. Turn Nut D clockwise to increase the cut height or anti-
clockwise to decrease the cut height;
3. Match the height of the roller on both sides of the machine
by checking the position of Arrow A;
4. When adjustment is complete, re-tighten Bolts B and C.
C
C
B
www.major-equipment.com
B
A
1
5
2
4
VIEW USED IN MANUAL.
D
C
5
3
11
IF IN DOUBT ASK
THE INFORMATION CONTAINED IN THIS DRAWING IS THE PROPERTY
OF MAJOR EQUIPMENT INTL. LTD.
Vendor:
FAB
ANY REPRODUCTION IN PART OR A WHOLE WITHOUT THE WRITTEN
PERMISSION OF MAJOR EQUIPMENT INTL. LTD. IS PROHIBITED.