Pairing Cameras; Troubleshooting - FLIR Lorex LH070 Series Instruction Manual

Table of Contents

Pairing Cameras

If you bought a bundle system, the cameras and the receiver have already been paired out

of the box, which means that they are exclusively communicating with each other. If you

have purchased add-on cameras, or if for some reason the pairing is lost, follow the steps

below to pair the cameras and receiver.

Prerequisites

• Ensure your DVR is powered on and connected to a TV or monitor.

To pair the cameras to the receiver:

1. Make sure that the cameras and receiver are both powered up and all antennas are

properly attached.

2. On the recorder's on-screen display, click the channel you want to pair the camera to.

The camera toolbar appears.

NOTE

If you pair a new camera to a channel that is already being used by an existing camera, the new cam-

era will be connected to that channel. The old camera will automatically be disconnected.

3. Click

and press the pair button on the camera to activate the pairing mode. This

must be done within 30 seconds of clicking the

If pairing is successful, live video from the camera will appear on the monitor.

NOTE

If you do not press the Pair button on the camera during the 30 second pairing window, repeat the above

steps to try the pairing process again.

If for some reason the camera image does not appear on the monitor, try the following

troubleshooting methods:

• Press and hold down the pair button on the camera until you see an image.

• Ensure that the camera is in range of the receiver.

• Remove obstructions between the receiver and camera.

• Avoid installing cameras in locations that require the wireless signal to pass through ce-

ment, concrete and metal structures. This will reduce the transmission range.

• Try repositioning the camera, receiver or both to improve the reception.

#LX400080; r.40436/40436; en-US

icon.

Table of Contents