Table of Contents
Advertisement
3. Press function button 4.
The 3 IN 1 indicator indicates the current setting:
Indicator
Indicator
4. Pressing function button 4 changes the setting.
5. If the 3 IN 1 indicator is indicating the desired setting, press the ON/
OFF button. The setting is now saved.
Before the start of the dishwashing cycle put 3in1 detergent in the de-
tergent dispenser.
3
As the rinse aid inflow is automatically switched off when the 3in1
function is activated, it may come about because of the different qual-
ity standards in the 3in1 detergent, that the dishes do not dry suffi-
ciently.
If this happens, proceed as follows (see section "Adding rinse aid"):
• Fill up the dispenser (if this is empty) with rinse aid.
• Set rinse aid dosage to "2" mechanically.
• Activate rinse aid inflow.
If you do not want to use 3in1 products any more
If you want to stop using 3in1 products, please do the following:
• Deactivate the 3in1 function.
• Fill up the dispensers for salt and rinse aid again.
• Switch the water softener to the highest setting and perform up to
three normal cycles without loading any dishes.
• Then set the water softener to the water hardness in your area.
If you want to use 4in1 products
When using "4 in 1" detergents that integrate also anti- glass corrosion
agent into "3 in 1" formula, please follow the same indication as given
for "3 in 1" detergents.
18
3 IN 1
is lit
3 IN 1
is not lit
3 in 1 function activated
3 in 1 function not activated
(factory setting).
Advertisement
Table of Contents
