Chassis Intrusion Connector; Front Panel Connector - DFI CS330 User Manual

Chassis Intrusion Connector

The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
BIOS Setting
Configure the chassis intrusion detection function in the Advanced menu ("NCT6106D HW
Monitor" submenu) of the BIOS. Refer to the chapter 3 for more informaiton.
Chapter 2 Hardware Installation
Chapter 2

Front Panel Connector

Chassis
Intrusion
1 Signal
2 Ground
HD-LED - Hard Drive LED
This LED will light when the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
ATX-SW - Power Switch
This switch is used to power on or off the system.
HD-LED
RESET
25
Front
Panel
Pin Pin Assignment Pin Pin Assignment
3 HDD Power 2 LED Power
5 Signal PWR-LED 4 LED Power
7 Ground 6 Signal
9 RST Signal 8 Ground
ATX-SW
11 N.C. 10 Signal
1 2
PWR-LED
HD-LED
RESET
ATX-SW
11 12
www.dfi.com