Yamaha YXZ 1000R SS Owner's Manual page 46

 The engine may not start even though the
starter motor operates.
If the YCC-S system stops working correctly
while driving, the YCC-S warning light will
come on. If this occurs, it may be impossible
to shift out of the gear you are in; and the
4
clutch may stay engaged, so a shuddering
sensation may be felt when you come to a
stop. Stop the vehicle on level ground safely
off the main trail, and have the YCC-S system
serviced by a Yamaha dealer before further
operation.
TIP
If shifting into neutral is impossible using the
shift paddles and drive select lever, proceed
as follows if it is necessary to move the vehi-
cle after it has stopped.
1. Turn the key to "
2. Remove panel B (page 8-11).
" (off).
3. While rocking the vehicle back and forth,
push the shift rod and shift arm pivot
downward (or upward if the transmission
was in reverse) until the transmission is in
neutral.
2
1. Shift arm pivot
2. Shift rod
3. Neutral position
EWB04171
WARNING
 Turn the key to "
ing to manipulate the shift rod. Other-
wise, the shift actuator may operate
unexpectedly and cause injury.
4-8
5 5 5
4 4
1
3 3
2 2
1 1
N N 3
R
R
" (off) before attempt-