Front feed (Push)
F
EEDING CONTINUOUS FORMS
R
(
)
EAR FEED
PUSH
1.
Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in
paper" on page
2.
Ensure the Paper Type Lever is set to Continuous Forms "REAR".
3.
Open the Top Cover and adjust the Paper Thickness Lever to suit the paper.
"Setting the Paper Thickness lever" on page 33.
After adjusting, close the Top Cover.
NOTE
If the Paper Thickness Lever setting does not match the paper being used,
paper feeding and printing may not work properly.
4.
Remove the top tray by holding the tray by the tabs on both sides and pulling it up
from the printer.
75 cm
3 cm
30.
Paper handling > 19
60 cm
"Ejecting cut sheet
REAR
See