L
OADING CONTINUOUS FORMS
S
ETTING UP CONTINUOUS FORMS
To avoid paper feeding problems, carry out the following:
1.
Check your printer is on a surface approximately 75 cm
above the floor.
2.
Position the continuous forms supply directly below the
printer, no more than 3 cm left or right of the printer
paper path.
3.
Ensure the rear of the printer is close to and parallel with
the edge of the surface and at least 60 cm from any wall.
F
EEDING CONTINUOUS FORMS
1.
Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in
"Ejecting cut sheet paper" on page
2.
Set the Paper Type Lever to Continuous Forms
ML1120/ML1190 eco User's Guide – Paper handling > 21
(
)
REAR FEED
20.