Dell PowerEdge FC830 Owner's Manual page 87

4. Remove the IDSDM card.
CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the
system.
Steps
1. Align the following:
● The slot on the card edge with the projection tabs on the PCIe mezzanine card support.
● The two screw holes on the IDSDM card with the standoffs on the system board.
● The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Figure 31. Installing the IDSDM card
1. IDSDM card
3. SD card slot bracket
5. connector
Next steps
1. If applicable, install the SD card(s) and the internal USB key.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system
Replacing the optional internal USB memory key
Replacing an SD card on page 83
After working inside your system
on page 48
on page 84
on page 49
2. screw (2)
4. PCIe mezzanine card support bracket
6. standoff (2)
Installing and removing sled components 87