Dell PowerEdge FC830 Owner's Manual page 68

Related tasks
Before working inside your system
Installing a processor on page 74
Installing a heat sink on page 75
Installing a processor blank and DIMM blank
After working inside your system
Installing a processor blank and DIMM blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove processor blank and DIMM blank when installing four processors or service other components
inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the heat sink and the processor.
4. Ensure that the memory module socket ejectors are in the open position.
Steps
1. Align the processor blank and DIMM blank with the memory module sockets on the system board.
2. Lower the processor blank and DIMM blank onto the memory module sockets such that the bottom edges of the blank is
firmly inserted into the memory module sockets.
3. Press the blank firmly until the memory module socket ejectors click into place.
Figure 17. Installing a processor blank and DIMM blank
1. processor blank and DIMM blank
68 Installing and removing sled components
on page 48
on page 68
on page 49
2. tab on the processor blank and DIMM blank (4)