Dell PowerEdge FC830 Owner's Manual page 25

2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Related references
Network Settings on page 24
Network Settings screen details
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option Description
PXE Device n (n Enables or disables the device. When enabled, a UEFI boot option is created for the device.
= 1 to 4)
PXE Device n Enables you to control the configuration of the PXE device.
Settings(n = 1 to
4)
Related references
Network Settings on page 24
Related tasks
Viewing Network Settings
UEFI iSCSI Settings
You can use the iSCSI Settings screen to modify iSCSI device settings. The iSCSI Settings option is available only in the UEFI
boot mode. BIOS does not control network settings in the BIOS boot mode. For the BIOS boot mode, the option ROM of the
network controller handles the network settings.
Related references
UEFI iSCSI Settings details
Related tasks
Viewing UEFI iSCSI Settings
Viewing UEFI iSCSI Settings
To view the UEFI iSCSI Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
on page 25
on page 24
on page 26
on page 25
Pre-operating system management applications 25