Dell PowerEdge FC830 Owner's Manual page 127

Installing an expander card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
certified service technicians.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 and #2 Phillips screwdrivers ready.
4. Remove the expander card.
NOTE: You must remove the expander card to replace a faulty expander card.
Steps
1. Align the slots on the expander card with the standoffs on the chassis.
CAUTION: To prevent damage to the expander card, hold the card only by its edges.
2. Lower the expander card in to the chassis until the slots on the expander card engage with the standoffs on the chassis.
3. Tighten the screw to secure the expander card to the chassis.
4. Align the expander-card cable connector with the connector on the system board (J_PERC).
5. Tighten the retention screws on the expander-card cable connector until the connector is seated firmly.
Figure 68. Installing an expander card
1. screw 2. expander-card cable connector
Installing and removing sled components 127