Dell PowerEdge FC830 Owner's Manual page 54

Installing the cooling shroud
After working inside your system
Installing the cooling shroud
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
NOTE: You must remove the cooling shroud to replace a faulty cooling shroud or service other components inside the
system.
Steps
1. Align the slots on the side of the cooling shroud with the standoffs on the cooling shroud retention bar.
2. Lower the cooling shroud into the system until the slots on the cooling shroud engage with the standoffs on the cooling
shroud retention bar.
3. Slide the cooling shroud to the lock position.
4. Tighten the retention screw to secure the cooling shroud on the cooling shroud retention bar.
Figure 10. Installing the cooling shroud
1. slot (2)
3. retention screw
54 Installing and removing sled components
on page 54
on page 49
2. cooling shroud
4. standoff on the cooling shroud retention bar (2)