Dell PowerEdge FC830 Owner's Manual page 48

Installing and removing sled components
This section provides information about installing and removing the sled components. For information about installing and
removing the enclosure components, see the enclosure Owner's Manual at Dell.com/poweredgemanuals.
Topics:
• Safety instructions
• Recommended tools
• Sled
• Inside the sled
• Cooling shroud
• Cooling shroud retention bar
• System memory
• Processor blank and DIMM blank
• Processors
• PCIe mezzanine card
• PCIe mezzanine card support bracket
• Internal dual SD module (optional)
• rSPI card (optional)
• SD vFlash card
• Network daughter card
• Hard drives or SSDs
• Hard-drive or SSD cage
• Hard drive or SSD backplane
• Storage controller card
• Expander card
• System battery
• System board
• Trusted Platform Module
Safety instructions
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: Dell recommends that you always use an antistatic mat and antistatic wrist strap while working on components
inside the system.
CAUTION: Operating the system without the system cover can result in component damage
NOTE: To ensure proper operation and cooling, all bays in the system must be populated always with either a system
component or with a blank.
Before working inside your system
Steps
1. Turn off the sled using the CMC.
2. Remove the sled from the enclosure.
48 Installing and removing sled components
6