Dimplex CDFI1000-PRO Owner's Manual page 7

Installation
appliances on the same circuit may
exceed the current rating of the
circuit breaker.
WARNING: Failure to install the
cassette as instructed below
may result in damage to the
equipment and or may expose
the user to the risk of fire,
serious injury, illness or death.
WARNING: Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: Ensure that the
On/Off switch is set to the OFF
position (refer to Operation
section) and that the circuit on
which the unit is to be installed
has the power cut off at the
service panel until installation is
complete.
!
NOTE: Please read all
instructions before installing.
Cassette Plumbing
The units come equipped with
refill containers for manual filling
of the reservoir. The unit can be
hard plumbed with the plumbing
accessory kit - CDFIPLUMB-KIT,
available from your local Dimplex
dealer, or with standard 1/4 in
(6.4mm) tubing, using the information
outlined below.
!
NOTE: The plumbing accessory kit
is designed for use with copper piping.
Figure 1
CDFI500-PRO
Ball
Valve
To water
Filter
source
Route the 2 pin wire as shown. 2 pin
wire for connecting to optional Heater
CDFI1000-PRO
To water
Ball
source
Valve
CAUTION: Ensure that all
plumbing connections meet local
plumbing code requirements.
CAUTION: Ensure that the
location of the plumbing connection
allows for easy access to allow
for shutoff during scheduled
maintenance.
1. Locate a cold water line in the
vicinity of the desired location
of the cassette.
!
NOTE: Normal tap water can
be used in the Opti-myst
as the tap water is not considered
to be hard water. In the event
your tap water is hard, softened or
filtered water is recommended.
Electrical
Junction Box
Air in
Electrical
Junction Box
Filter
Air in
as long
®
7