Dimplex CDFI1000-PRO Owner's Manual page 11

Installation
ground wire (3 wires total) for the
incoming power supply on the
cassette. Use appropriate wire to
meet local and national electrical
codes for rated power.
!
NOTE: When installing multiple
units in the same vicinity they will
need to be wired in parallel.
!
NOTE: The Opti-myst
is designed to allow for installation
of a wall switch to control the
incoming power to the unit.
4. Connect the black wire (live)
from the unit to the live from
the power supply.
5. Connect the white wire
(neutral) from the unit to the
neutral wire from the power
supply.
6. Connect the green wire
(ground) from the unit to the
ground wire from the power
supply.
7. Place all connectors inside
the unit and secure the cable
clamp to unit, making sure that
the cable clamp grips only the
jacket of service cable.
WARNING: Ensure the power
wiring is not installed so that it
is pinched or against a sharp
edge and ensure that the power
wiring is stored or secured to
avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
8.
9.
cassette
®
10. Secure the unit to the
Operation Preparation
1.
2.
3.
Install the unit into the roughed
in framing ensuring that the unit
is resting on two framing sills,
one at the front and one at the
back or a level surface. Ensure
an air opening is maintained.
Level the housing - right to left
and front to back, using the
adjustable feet on the bottom of
the unit.
permanent framing on either
end through a minimum of two
holes (Figure 4).
After the surrounding area has
been dry walled and finished,
remove the media plate from
the unit.
Unwrap the tethered controller
and ensure that the wire is
lead through the opening in
the bottom of the unit where
the hard plumbing attaches.
(Figure 4)
Locate the tethered controller
so that:
a) it can be easily accessed, if
being used as the main controls,
or
b) it is not obscured by either
bricks, stone or sheet metal so
that the signal that is sent from
the remote control can be easily
picked up.
11